Manufacturing Technology and Application Prospect of Ceramic Fiber

Sep 19, 2018

There are three methods of making ceramic fibers: the spinning method, the blowing method and the spinning method. The ceramic fiber in the ceramic fiber paper is commonly used by the blowing method. The blowing method is to spray the molten mixed raw materials to the peripheral surface of the high-speed rotating disc in a fine flow state under the pressure of an inert gas. Under the pulling force of the high-speed rotation of the disc, the spun filaments are wound on the disc to obtain ceramic fibers of several microns.


The ceramic fibers used for making ceramic fiber paper must be purified to remove unqualified non-fibrous ceramic particles. Then use a beater to adjust the fiber length appropriately, making sure that the length-to-width ratio of the fiber is equal to or more than 10. During the flow process, the ceramic fibers should be kept in a suspended and dispersed state. It can be made on conventional fourdrinier wire, rotary wire, inclined wire and other paper machines.


According to the application of the product, the binder can be added to the slurry before making ceramic fiber paper, or it can be omitted. However, in order to meet the strength required by industrial production, high-temperature binders have been added to the ceramic fiber paper currently produced.


Ceramic fiber is widely used in thermal insulation and high temperature resistant materials of various thermal kilns. Because its bulk density is much lower than other refractory materials, the heat storage is very small and the heat insulation effect is obvious. As a furnace lining material, it can greatly reduce the thermal kiln. Energy loss has brought a revolution to thermal kilns in terms of energy saving. On the other hand, its application technology and methods have also brought a revolution to the masonry of thermal kilns.


At present, "resistance blowing into fiber, dry acupuncture to make blanket" and "resistance spinning to fiber, dry acupuncture to make blanket" are still two typical process technologies for ceramic fiber production in the world. As the application range of ceramic fibers is expanding, and with the development of high-tech, ceramic fiber products are required to develop in a functional direction to meet the special functional products required in specific fields, such as making the products have excellent high temperature resistance. performance, mechanical properties, flexibility and spinnability. In terms of manufacturing methods, the melting method and the chemical method coexist and develop simultaneously to meet the needs of different varieties of applications. The melting method is often used to produce amorphous fibers. It has low technical content, low production cost, and a wide range of applications. It is mainly used as a basic material in the fields of industrial furnaces, heating devices, refractory, and heat insulation. The chemical method is used to produce polycrystalline fiber. This method has high technical content, high production cost and high added value, but the products are still few. , nuclear energy and other cutting-edge technologies.